收藏本站
Si4313-B1
8.4. Wake-Up Timer and 32 kHz Clock Source
The chip contains an integrated wake-up timer which can be used to periodically wake the chip from SLEEP mode.
The wake-up timer runs from the internal 32.768 kHz RC Oscillator. The wake-up timer can be configured to run
when in SLEEP mode. If enwt = 1 in "Register 07h. Operating Mode and Function Control 1" when entering SLEEP
mode, the wake-up timer will count for a time specified defined in Registers 14–16h, "Wake Up Timer Period." At
the expiration of this period an interrupt will be generated on the nIRQ pin if this interrupt is enabled. The
microcontroller will then need to verify the interrupt by reading the Registers 03h–04h, "Interrupt Status 1 & 2". The
wake-up timer value may be read at any time by the wtv[15:0] read only registers 17h–18h.
The formula for calculating the Wake-Up Period is the following:
WUT ?
4 ? M ? 2 R
32 . 768
ms
WUT Register
wtr[4:0]
wtm[15:0]
Description
R Value in Formula
M Value in Formula
Use of the D variable in the formula is only necessary if finer resolution is required than can be achieved by using
the R value.
Add R/W Function/Description
14
R/W
Wake-Up Timer Period 1
D7
D6
D5
D4
wtr[4]
D3
wtr[3]
D2
wtr[2]
D1
wtr[1]
D0
wtr[0]
POR Def.
03h
15
R/W
Wake-Up Timer Period 2
wtm[15] wtm[14] wtm[13] wtm[12] wtm[11] wtm[10] wtm[9] wtm[8]
00h
16
R/W
Wake-Up Timer Period 3
wtm[7]
wtm[6]
wtm[5]
wtm[4]
wtm[3]
wtm[2]
wtm[1] wtm[0]
00h
17
18
R
R
Wake-Up Timer Value 1
Wake-Up Timer Value 2
wtv[15]
wtv[7]
wtv[14]
wtv[6]
wtv[13]
wtv[5]
wtv[12]
wtv[4]
wtv[11]
wtv[3]
wtv[10]
wtv[2]
wtv[9]
wtv[1]
wtv[8]
wtv[0]
—
—
There are two different methods for utilizing the wake-up timer (WUT) depending on if the WUT interrupt is enabled
in “Register 06h. Interrupt Enable 2.” If the WUT interrupt is enabled then nIRQ pin will go low when the timer
expires. The chip will also change state so that the 30 MHz XTAL is enabled so that the microcontroller clock
output is available for the microcontroller to use to process the interrupt. The other method of use is to not enable
the WUT interrupt and use the WUT GPIO setting. In this mode of operation the chip will not change state until
commanded by the microcontroller. The different modes of operating the WUT and the current consumption
impacts are demonstrated in Figure 11.
A 32 kHz XTAL may also be used for better timing accuracy. By setting the x32 ksel bit in Register 07h "Operating
& Function Control 1", GPIO0 is automatically reconfigured so that an external 32 kHz XTAL may be connected to
this pin. In this mode, the GPIO0 is extremely sensitive to parasitic capacitance, so only the XTAL should be
connected to this pin with the XTAL physically located as close to the pin as possible. Once the x32 ksel bit is set,
all internal functions such as WUT, micro-controller clock, and LDC mode will use the 32 kHz XTAL and not the
32 kHz RC oscillator.
The 32 kHz XTAL accuracy is comprised of both the XTAL parameters and the internal circuit. The XTAL accuracy
can be defined as the XTAL initial error + XTAL aging + XTAL temperature drift + detuning from the internal
oscillator circuit. The error caused by the internal circuit is typically less than 10 ppm.
36
Rev. 1.0
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
SI4320-J1-FT IC RCVR FSK 915MHZ 5.4V 16-TSSOP
SI4322-A0-FT IC RX FSK UNI 868/915MHZ 16TSSOP
SI4324DY-T1-GE3 MOSFET N-CH D-S 30V 8-SOIC
SI4330-B1-FM IC RCVR ISM 960MHZ 3.6V 20-QFN
SI4354DY-T1-GE3 MOSFET N-CH D-S 30V 8-SOIC
SI4355-B1A-FM IC EZRADIO FM RECEIVER SI4355
SI4388DY-T1-GE3 MOSFET DUAL N-CH 30V 8-SOIC
SI4390DY-T1-GE3 MOSFET N-CH 30V 8.5A 8SOIC
相关代理商/技术参数
SI4313-B1-FMR 功能描述:射频接收器 240-960 MHz Receiver RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel
SI4315-A0-FT 功能描述:射频接收器 Receivers - IA4315 RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel
SI4320DY 制造商:VISHAY 制造商全称:Vishay Siliconix 功能描述:N-Channel 30-V (D-S) MOSFET
SI4320DY-T1 功能描述:MOSFET 30V 25A 1.6W RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS（导通）:0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube
SI4320DY-T1-E3 功能描述:MOSFET 30V 25A 3.5W 3.0mohm @ 10V RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS（导通）:0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube
SI4320DY-T1-GE3 功能描述:MOSFET 30V 25A 3.5W 3.0mohm @ 10V RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS（导通）:0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube
SI4320-J1-FT 功能描述:射频接收器 Receivers - IA4320 RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel
SI4320-J1-FTR 功能描述:射频接收器 Receiver (EZRadio) RoHS:否 制造商:Skyworks Solutions, Inc. 类型:GPS Receiver 封装 / 箱体:QFN-24 工作频率:4.092 MHz 工作电源电压:3.3 V 封装:Reel